Design class: EmergencyValidation status: Data validated

Emergency Cardboard Dry

A cardboard box with straw for a night or a few days, strictly under a roof: a porch, a doorway or a shed. It is not rain protection.

EMERGENCY ONLY
  • It must stay dry.
  • It must be raised off the ground.
  • It is not a replacement for a durable waterproof shelter.
  • Inspect it every day.
  • Replace it as soon as it gets damp or deforms.
Capacity1
Outside size500 × 400
BuildNo skill needed
Time (estimate)10 min–25 min
model v1.0.0compiler P1.0.0plan ed54de49c6429615Emergency wrapEmergency
SCHEMATIC ENVELOPE500 mm

This model has no 3D view; the drawing and dimensions below fully describe the construction.

Who this is for
  • For someone who has to protect an animal tonight with whatever is at hand.
  • For one cat, including community cats.
When not to use it
  • As a permanent shelter: this is emergency-only and must be replaced as soon as possible.
  • Outside without a roof above it: it must stand under a canopy, in a shed or a doorway.
  • For young, old, sick or unacclimated animals without extra protection and supervision.
Tools and calculations
Required tools
Utility knife
Budget class
Free / reused
Location
Covered location only
Supported calculations
Geometry, Bill of materials, Cost estimate, Drawing, Build guide
Build time is a planning estimate, not a promise.
Geometry

Dimensions

Front, side and top views. Outside size 500 × 400 mm, front height 350 mm, rear 350 mm.A · FRONT VIEWB · SIDE VIEWC · PLANSCHEMATIC ENVELOPE: MEASURE YOUR PRODUCT500 mm430 mm400 mm430 mm500 mm
Text equivalent of the drawing
Outside size (W × D)500 × 400 mm
Height front / rear350 / 350 mm
Raised off the ground80 mm
Entrance1 × 150 × 150 mm, sill 80 mm
Chambers1
Geometry typeschematic envelope (assumption)
Bill of materials · compiler output

What you have and what to obtain

Quantities come from the model geometry; items marked as assumptions are planning allowances. Reused material must pass the checklist.

Fill in “My workshop” to see what you still need to buy.

My workshop
MaterialNeededOwnedStatus
Corrugated cardboard1 pcs–Buy
Heavy-duty tape1 pack–Buy
Bricks4 pcs–Buy
Straw1 bale–Buy
  • Corrugated cardboard1 pcsfrom geometry · A dry, clean container of a suitable size.
  • Heavy-duty tape1 packassumption · Tape on the outside only.
  • Bricks4 pcsassumption · Four stable supports under the corners.
  • Straw1 baleassumption · Loosely to a quarter or half of the height; keep the rest dry for refills.
Water and moisture

Weather exposure

A warm shelter that gets damp can be worse than a simpler one that stays dry. This is an explanation, not a condensation calculation.

  • Ground contactRaised about 80 mm off the ground.
  • Rain splashRain splash from the ground can reach the floor and lower edges; protect the edges.
  • Roof drainageThe lid is flat: water runs off to the sides. It must close well and the entrance must not sit below a drip edge.
  • Rain at the entranceThe entrance sill is 80 mm above the floor.
  • DryingWithout a service opening drying and cleaning are harder; change bedding through the entrance.
  • Absorbent materialThe material absorbs moisture; check it more often and replace it when damp.
  • Maintenance accessAccess for checks and cleaning is simple.
Placement

Check the spot

Tick what applies to the chosen spot
No obvious issue detected

This is not a safety certificate for the spot: it only means none of the listed questions is ticked.

Bedding

What goes inside

  • AcceptableBlanketAbsorbs and holds moisture; a damp blanket chills. Wash and swap as soon as it is damp.
  • AcceptableTowelAbsorbs moisture like a blanket. Wash and swap as soon as it is damp.
  • AcceptableWashable dog bedDepends on fabric; textile absorbs moisture. Dry or swap as soon as it is damp.
Maintenance

Inspection schedule

  • DailyCheck that the straw is dry and loose; replace it when damp or compacted.
  • DailyCheck for water or dampness on the floor and walls, especially under the entrance.
  • After stormsAfter rain or snow check the interior and the ground under the shelter.
  • DailyReplace cardboard immediately if it is soft, damp or deformed.
  • After stormsClear snow from entrances and exits so the animal cannot be snowed in.
  • WeeklyClean the interior; service access must allow cleaning without dismantling.
Upgrade path

Where to go next

Each step states what you add, what you gain and what stays limited. A new model has a new plan ID; changing an existing build has no canonical plan.

New model · new plan IDWaterproof Emergency Shelter →
You add
An outer film wrap and raising on bricks.
You gain
Can stand briefly at a sheltered outdoor spot.
Still limited
Still cardboard: emergency only, daily checks, replace when damp.
New material
Waterproof sheet or heavy bag, Bricks
Build sequence

Build steps

Progress is stored in this browser against the exact plan ID; it works offline once the page has been opened.

0 / 6steps completed
  1. Prepare the container

    Take a dry, clean corrugated cardboard. Close and secure the sides so the box cannot open.

  2. Cut the entrance

    Cut a 150 mm × 150 mm opening through corrugated cardboard, with the sill 80 mm above the floor so rain and snow stay out. Face the entrance away from the prevailing wind. Cover or sand sharp edges.

  3. Raise the shelter off the ground

    Set the shelter on four stable bricks, about 80 mm above the ground, so the floor does not touch cold, wet ground. Check that it does not rock.

  4. Add straw, not hay

    Loosely fill straw to a quarter or half of the interior height. Do not use hay, towels or blankets in an outdoor winter shelter: they absorb moisture and chill.

  5. Choose the spot and secure it

    Set it against a wall or fence, out of the wind, away from roof runoff and roaming dogs. Weight or secure lightweight shelters. Check the spot with the placement checklist.

  6. Check every day

    This is an emergency solution only. Check daily that it is dry; as soon as the cardboard gets damp or deforms, replace it. Move to a durable waterproof shelter as soon as possible.

Provenance

Sources and verification status

A source supports a guideline or material value, but it does not confirm this specific model. Container sizes are assumptions and build time is a planning estimate.

  1. Data validatedcurrent
  2. Geometry validatednot confirmed
  3. Engineering reviewnot confirmed
  4. Physical prototypenot confirmed
  5. Field validationnot confirmed